If this tiny hole gets clogged or blocked the injector will not be able to create a draw and therefore the water softener will not get the brine that it needs to regenerate the water softener resin in its tank.
Clogged venturi water softener.
Rinse the venturi nozzle and pieces.
A top basket that is clogged will prevent adequate backwashing and backwashing is the means the softener uses to clean itself the resin actually of dirt.
During regeneration there are two cleaning cycles that are absolutely critical.
This diy repair guide and video show to how to replace a water softener venturi in 15 minutes or less.
If your water softener leaks at the bottom of the brine tank or if the tank is overflowing it could be the venturi is clogged or damaged.
Place the water softener s venturi nozzle in the bowl of soapy water and let it soak for a few minutes.
If they become clogged with silt or dirt the water softener stops working.
A tell tale sign that your water softener might be clogged is if the softness of your water changes considerably.
The nozzle and venturi in a water softener draw the brine into the resin bed during the regeneration cycle.
Use a soft bristle brush to clean the venturi nozzle and all the parts gently.
The venturi draws brine into the resin tank to regen.
Before you do make sure the water softener is in service mode not regeneration mode.
Clogs most often occur in two areas including.
Some softeners have a top basket that can colllect dirt but that causes water flow reduction not dirty water.
How to fix it.
Click on symptoms and then check flooded salt tank.
And dirt is rarely a sufficient reason to replace resin.
I checked and there is a salt bridge what s next.
A water softener has a screen located before the injector to prevent debris from getting into the injector.
A brine tank needs to be thoroughly cleaned once every year as recommended.
The original site stopped working.
You can remove and clean the nozzle.
If you are starting to see chalky deposits on your dishware and fixtures when you didn t have this issue before this could be a sign that your water softener is clogged.
Salt bridge problems are almost completely eliminated by separating the resin tank and brine tank into 2 separate free standing units.
This one does not work in chrome.
Mix a solution of liquid dish or hand soap in a small bowl of water.
For instance a clogged venturi valve or blocked control valve and misconfigured timer can cause overflowing water in your salt tank.