His observation is that filter inside my water softner is probably clogged.
Clogged water softener filter.
The water softener will regenerate and clean these beads at night.
The result is the softener cannot regenerate properly and you will get hard water.
A typical way to know if you have a clogged injector is to check if the water in the brine tank is.
Tap water can contain from 25 to 500mg per liter of water.
If the membrane that holds the resin beads were to break the beads are then free to travel throughout your plumbing system.
Troubleshooting your potentially clogged water softener or iron filter is very straight forward all you need to do is temporarily bypass it.
Zero water filters are supposed to bring the tds level down to zero hence the name.
Dirty filters most softeners have sediment filters that are used to filter out sediment before they reach the resin bed.
I called water dept.
And they sent out the inspector.
Water pressure has been seriously decreased and when turned on lots of sediments come out of all faucets in the house.
Have you noticed that your water pressure or flow is worse now than it used to be.
There are two parts of a water softener that prone to clogging sediment filters and resin bed.
If there is no difference you ll need to check elsewhere.
A common telltale sign that the membrane has broken is low water pressure and one of the common culprits for low water pressure is the water softener.
The injector in your water softener can get clogged with debris over time.
If you see that there is a noticeable difference with the water softener bypassed then the clog is in the water softener.
This can affect the water softener s ability to create suction for the brine cycle.